Omnitronic XO-23 Active crossover User Manual download pdf (Page 23)

10355625_V_1_0.DOC

23/35

3-way mono operation

Activate the mono mode via the MODE switch on the rear panel.

Please adjust the desired seperation frequency between mids and highs via the MID/HIGH XOVER

Frequency Control. Make sure that the XOVER Frequency Switch is active. The frequency range ranges

from 450 Hz to 9.5 kHz.

The portion of the mids can then be cut via the Mid Level Control.

The portion of the highs can then be cut via the High Level Control.

Example for setting the frequency ranges (depending on the system and the room):

Bass Mids Highs

40-250 Hz 250-6 kHz 6-20 kHz

Please adjust the desired seperation frequency between lows and mids via the LOW/MID XOVER

Frequency Control. Make sure that the XOVER Frequency Switch is not active. The frequency range ranges

from 45 Hz to 950 Hz.

The portion of the bass can then be cut via the Low Output Level Control.

With the Input Control, you can adjust the incoming signal level from -

∞

to +6 dB.

With the Low Level and High Level Controls, you can adjust the respective output level from -

∞

to +6 dB.

For stereo mode two units, which are set identiclly, are needed.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

No comments

Omnitronic XO-23 Active crossover User Manual Page 23